●Sample collection
Use cotton swab for good test performance
Included in the kit.
●Nasopharyngeal swab sample:
It is important to get as many secretions as possible. Therefore, the nasopharynx
Wipe the sample with a cotton swab and carefully insert a sterile cotton swab.
Nostrils with the most secretions
Eye examination. Place a cotton swab near the septum
Gently press the bottom of the nose with a cotton swab
Behind the nasopharynx. Rotating swab
Several times.
●Oropharyngeal Swab Sample:
It is important to get as many secretions as possible.
Therefore, in the case of an oropharyngeal swab,
Insert all sterile cotton swabs included in this kit
Deep in the throat
Other inflamed areas of tonsils and throat.
Don't touch your tongue or cheeks
Or brush your teeth with a cotton swab.
It is advisable to obtain a specimen
Primarily uses nasopharyngeal swabs
●Accurate results.
●Transport and storage of samples:
Samples should be tested as soon as possible after collection. Yes
Sample delivery is required. The next delivery medium is
Recommended and tested and shown to be non-interfering
Performance tested: Hanks Balance MKd Salt Solution, M5 Media or
salt water. Alternatively, refrigerate the sample (2-8°C) or
Store in a clean, dry and airtight container at room temperature (15-30°C)
8 hours before the test.
● Program
Bring tests, samples and/or controls to room temperature
(15-30°C) Before use. Remove the test from the airtight bag and place it
Place it on a flat, clean surface. Label the device with the patient or control
identification. For best results, the test should look like this:
time.
Prepare the extraction solution.
Disposable extract: open the bottle and add everything
Contains the extract
Extraction pipe.
Extraction sticker
Aluminum foil: Carefully peel off the aluminum foil.
●Sample Processing:
1. After collection, place the swab in a test tube.
2. While pressing down on the swab, rotate the swab at least 20 times.
Pull the bottom and sides of the tube. 3. Roll the swab tip into the extraction tube
Exclude it. Try to release as much liquid as possible. dispose
A cotton swab was used in accordance with biohazard waste disposal protocol.
4. Attach the tip.
5. Add 3 drops of the extracted sample to the sample well. does not treat
You can also move the test device around until the test is complete and ready to read.
6. When the test starts running, the color will transfer to the film.
Wait for the colored bar to appear. Results should be read at 10 a.m.
Minutes. Do not interpret results after 20 minutes.
Results interpretation
Positive result: colored bands appear in the control band area (C)
A band of another color appears in the T-band area
Negative result: A colored band appears on the control
Tape (C). No band is displayed in the test band area (T)
Invalid Result: The control strip could not be displayed. Test results
If no control bandwidth is generated within the specified playback time,
Discard. Please check the procedure and try the new test again. Yes
If the problem persists, stop using the kit immediately and
Your local dealer.