The test takes around 10mins.
Check more details about the operation procedure below
Bring tests, specimens, and/or controls to room temperature (15-30°C) before use. Remove the test from its sealed pouch, and place it on a clean, level surface. Label the device with patient or control identification. For best results, the assay should be performed within one hour.
Aluminum film buffer(Pre-filled)
Single-use buffer(Unpre-filled):
Open the buffer and add all the buffer into the extraction tube.
Buffer sealed with aluminum film:
Carefully remove the sealing film.
· Specimen treatment:
1. After the sampling, place the swab specimen into the tube.
2. Roll the swab at least 20 times while pressing the swab against the bottom and side of the extraction tube.
3. Roll the swab head against the inside of the Extraction Tube as you remove it. Try to release as much liquid as possible. Dispose of the used swab in accordance with your biohazard waste disposal protocol.
4. Put on the tube tip.
5. Add 3 drops of extracted sample into the sample well. Do not handle or move the Test Device until the test is complete and ready for reading.
6. As the test begins to work, the color will migrate across the membrane. Wait for the colored band(s) to appear. The result should be read at 10 minutes. Do not interpret the result after 20 minutes.
